Skip to content

What is support and resistance in trading?

Support is a price area where a falling market has repeatedly stopped falling, because buying has outweighed selling there. Resistance is the opposite, an area where rises have stalled. They are zones, not exact lines, and they break often. Once broken, a support area often acts as resistance, and the other way round.

Fintrix trading desk •

What is support and resistance in trading?

Support is a price area where a falling market has stopped falling more than once, because buyers have outweighed sellers there. Resistance is an area where a rising market has stalled, because sellers have outweighed buyers. On a chart you see them as a floor and a ceiling that price keeps returning to.

The textbook definition, quoted in a Federal Reserve Bank of New York study: support is "a level or area on the chart under the market where buying interest is sufficiently strong to overcome selling pressure", and resistance is the opposite (John Murphy, Technical Analysis of the Futures Market, 1986). Note the word "area". Support and resistance are zones a few pips or dollars wide, not single prices, and treating them as exact lines is the most common mistake beginners make with them.

They are also the most widely used tool in technical analysis. Carol Osler of the New York Fed found that support and resistance levels were the only indicator provided by all six of the forex research services she studied, and that some provided nothing else (Economic Policy Review, 2000).

A real example: EUR/USD, October to November 2026

From mid-October to early November, EUR/USD moved inside a clear range on the daily chart (Fintrix Markets MT5 data, trading server time UTC+2):

Date Price
Support touches Wed 14 Oct, low 1.11130
Wed 28 Oct, low 1.11131
Thu 29 Oct, low 1.11046
Resistance touches Fri 16 Oct, high 1.12694
Tue 20 Oct, high 1.12608
Wed 4 Nov, high 1.12731
Thu 5 Nov, high 1.12682
Break Wed 11 Nov, close 1.10898
Retest from below Thu 12 Nov, high 1.11028

Three lows landed within 8.4 pips of each other, between 1.11046 and 1.11130: that is the support zone. Four highs landed within 12.3 pips, between 1.12608 and 1.12731: the resistance zone. On 11 November the euro closed below the support zone for the first time. The next day it bounced to 1.11028, just under the bottom of the old support zone, and turned lower again. By the close on 16 November it was at 1.09975.

That one chart shows the three ideas in this lesson: support and resistance are zones, they eventually break, and a broken support often becomes resistance.

How do you identify support and resistance?

Start from the price history, not from an indicator.

  1. Pick the timeframe you trade on, then check one higher. Levels on a daily chart matter more than levels on a 5-minute chart, because more traders see them and more orders sit there.
  2. Mark the swing highs and lows. A swing low is a candle whose low is lower than the candles on either side. Look for places where two or more swing lows (or highs) line up.
  3. Draw a zone around the touches, not a line through one of them. Use the lowest and highest of the touches as the edges. In the example, the support zone runs from 1.11046 to 1.11130.
  4. Check the zone against volatility. The Average True Range (ATR) tells you how far the market typically moves in one bar. On 29 October, EUR/USD's 14-day ATR was 61.9 pips, so an 8-pip zone was narrow relative to a normal day. A zone much wider than one ATR is probably two separate levels.
  5. Note round numbers nearby. The support zone sat just above 1.1100. Round numbers attract orders, which is covered below.
  6. Count, but do not over-count. Each extra touch shows the level is watched. It also uses up some of the orders resting there, so a level tested five times in a week is not necessarily stronger than one tested twice.

Other tools are used to suggest levels, such as moving averages, trendlines, previous day highs and lows, and Fibonacci retracements, but they work the same way: they point to prices where many traders expect something to happen.

Set it up in MT4/5

  • Horizontal line: in MT5, Insert, then Objects, then Lines, then Horizontal Line; in MT4, Insert, then Lines, then Horizontal Line. Click on the chart at the level, then double-click the line to set an exact price.
  • Zone: use a rectangle (in MT5, Insert, then Objects, then Shapes, then Rectangle; in MT4, Insert, then Shapes, then Rectangle) drawn from the lowest touch to the highest.
  • ATR: Insert, then Indicators, then Oscillators, then Average True Range. The default period is 14 bars. A shorter period reacts faster to a change in volatility; a longer one is smoother.

Lines and rectangles stay on the chart across timeframes unless you change their visibility settings. For chart basics, see the Help Centre guide linked at the end of this lesson.

Why does support and resistance work?

Because orders cluster at levels that many traders can see, and those orders move the price when it gets there.

The best evidence comes from real order books. Osler examined almost 9,700 stop-loss and take-profit orders placed at a large dealing bank between September 1999 and April 2000 (New York Fed Staff Report 125). She found the orders were far from evenly spread:

  • Take-profit orders cluster exactly on round numbers. A take-profit order to sell at 1.1200 is selling into a rally at that price, so it tends to slow or reverse the move: one reason round numbers act as resistance or support.
  • Stop-loss orders cluster just beyond round numbers: stop-loss sells just below them, stop-loss buys just above. A stop-loss sell triggered below 1.1100 adds selling to a market that is already falling, which is one reason prices often move quickly once a level breaks.

Memory also plays a part. Traders who bought at a support level and saw it hold are likely to buy there again. Traders who missed the last bounce wait for the next one. Each group's orders add to the next test.

Does support and resistance really work?

Partly, and the evidence is more modest than most trading websites suggest.

Osler's 2000 study is the most direct test. She took the support and resistance levels that six firms sent to clients each morning from January 1996 to March 1998, and checked minute-by-minute prices in dollar-mark, dollar-yen and dollar-pound. When the rate reached a published level, it stopped trending (still on the right side of the level 15 minutes later) 60.8% of the time. For 10,000 sets of randomly chosen levels, the figure was 56.2%.

Three things in that result are worth knowing:

  • Random levels "hold" more than half the time too. A level holding is common whatever you draw. The published levels did better, by about 4.6 percentage points on average, which is statistically significant but small.
  • The analysts often disagreed. Only about 30% of possible matches between two firms' levels lined up within 5 points, and levels that several firms agreed on did not perform clearly better than levels from one firm.
  • The edge was weaker when markets were more volatile. In the second, more volatile half of the sample, the difference was no longer statistically significant in half of the cases.

The wider research on technical trading in currencies points the same way. Christopher Neely and Paul Weller of the St Louis Fed summarise it: simple technical trading rules on dollar exchange rates produced positive returns for about 15 years in the 1970s and 1980s "before those returns were extinguished", and more complex rules have since produced more modest returns for a similar length of time (Federal Reserve Bank of St. Louis Working Paper 2011-001).

A level holding is also not the same as a trade making money. Spread, slippage and the trades where the level breaks all count. Support and resistance are best used for what they do reliably: telling you where the market has reacted before, and where your idea is proved wrong.

Why does support become resistance?

When a support zone breaks, the traders who bought there are now holding losing positions. Many will sell if the price comes back to where they bought, to get out at a small loss or at breakeven. That selling meets the price on its way back up, so the old floor acts as a ceiling. The same logic works in reverse for resistance that breaks upward.

In the example, the euro's bounce on 12 November stopped at 1.11028, about 2 pips under the bottom of the old support zone, and the price fell a further 105 pips by the close on 16 November.

This "role reversal" is a tendency, not a rule. Some broken levels are never retested, and some are broken back through. And earlier research covered in Osler's paper found that breaking a currency level did not, on average, start a fast trend, except during periods of strong trending (Curcio and others, 1997).

How do traders use support and resistance to place a stop?

The most practical use of a support or resistance zone is deciding where a trade idea is wrong. If you buy because a support zone is holding, a close well below that zone says the reason for the trade has gone.

Worked example: sizing a trade around the EUR/USD support zone. Say a trader with a $10,000 account bought EUR/USD at 1.1130 on 29 October, as the price bounced off the support zone, and planned to risk 1% of the account ($100).

Step Calculation Result
Zone low Lowest touch 1.11046
Buffer 0.25 × ATR of 61.9 pips about 15 pips
Stop 1.11046 minus 15 pips 1.1090
Distance to stop 1.1130 minus 1.1090 40 pips
Position size $100 ÷ (40 pips × $10 per pip per lot) 0.25 lots

Two things then happened, and both are instructive.

  • The zone held for eight more trading days. The low on 29 October was inside the zone and the price closed 77 pips above it. A stop placed a pip or two under the earlier 1.1113 lows, as if the level were an exact line, would have been triggered that day, just before the bounce.
  • Then the zone broke. On 11 November the low reached 1.10826, below the 1.1090 stop. The loss was 40 pips × 0.25 lots × $10 = $100, plus any spread and slippage. Without the stop, the same position at the 16 November close of 1.09975 would have been 132.5 pips down: $331.

The buffer should come from volatility, not habit. A fixed 10-pip buffer means something very different on EUR/USD (ATR about 62 pips here) than on gold, where the 14-day ATR in mid-November 2026 was about $99. Our position size lesson covers the sizing step in detail, and our stop-hunting lesson explains why a stop parked just past a round number sits with everyone else's.

Support and resistance vs supply and demand: what is the difference?

They describe the same idea from two angles. Support and resistance are drawn from where price turned: swing highs and lows, usually as fairly narrow zones. Supply and demand zones are usually drawn from where price left quickly, the base before a sharp move, and are often wider. Both are guesses about where unfilled orders are waiting, and neither can see the order book directly.

Common mistakes with support and resistance

Mistake Why it hurts Better habit
Drawing exact lines Price overshoots by a few pips and stops are hit just before the turn Draw a zone from the lowest to highest touch
Too many levels Every price is "near a level", so none means anything Keep the two or three clearest on your timeframe
Ignoring the higher timeframe A 15-minute level can sit in the middle of a daily range Check one timeframe up
Assuming a level will hold Levels hold only a little more often than random ones Decide where you are wrong before you trade
Stops exactly past round numbers They sit in the same cluster as many others Use the zone plus a volatility buffer

Key takeaways

  • Support is an area where falling prices have stopped before; resistance is where rising prices have stalled. Both are zones, not lines.
  • Find them from swing highs and lows on your timeframe and the one above, and check zone width against ATR.
  • They work partly because orders cluster at visible levels: take-profits on round numbers, stop-losses just beyond them.
  • The evidence is modest: in a New York Fed study, published levels held 60.8% of the time against 56.2% for random levels.
  • Broken support often becomes resistance, as EUR/USD showed on 12 November 2026, but not always.
  • Their most reliable use is deciding where a trade idea is wrong, and sizing the position from that distance.
  1. 3 technical indicators new traders should know: moving averages, RSI and ATR
  2. How do you calculate position size in trading?
  3. Myth or fact: do brokers hunt your stop losses?
  4. What is the London breakout strategy?
  5. Help Centre: how to read charts on MT4/MT5

Sources

  • C. Osler, "Support for Resistance: Technical Analysis and Intraday Exchange Rates", Federal Reserve Bank of New York Economic Policy Review 6(2), July 2000 (bounce frequencies, agreement between firms, Murphy definition, Curcio and others 1997): https://www.newyorkfed.org/medialibrary/media/research/epr/00v06n2/0007osle.html
  • C. Osler, "Currency Orders and Exchange-Rate Dynamics: Explaining the Success of Technical Analysis", Federal Reserve Bank of New York Staff Report 125, 2001, later Journal of Finance 58(5), 2003 (clustering of stop-loss and take-profit orders): https://www.newyorkfed.org/medialibrary/media/research/staff_reports/sr125.pdf
  • C. Neely and P. Weller, "Technical Analysis in the Foreign Exchange Market", Federal Reserve Bank of St. Louis Working Paper 2011-001B (returns to simple technical rules over time): https://files.stlouisfed.org/files/htdocs/wp/2011/2011-001.pdf
  • Fintrix Markets MT5 data: EUR/USD (EURUSD) daily candles, 11 September to 17 November 2026, trading server time (UTC+2); 14-day ATR computed from the same candles. XAU/USD 14-day ATR from daily candles to 16 November 2026.

Put your knowledge to work

Open a Fintrix Markets account, or log in and trade CFDs on forex, gold, indices and more.